BATTLE Design Change - Bailwire, Line Roller and Line Roller Bearing

IMPORTANT CHANGE FOR BATTLE Spinning Reels

Bailwire, Line Roller and Line Roller Bearing Changed in models BTL5000, BTL6000, BTL7000, BTL8000
The I.D. of the line roller was changed to permit use of a slightly large ball bearing. The tip of the bail wire where the roller and bearing sit was also slightly increased to accommodate the larger bearing.

When ordering these parts, make sure to check the diameters, so that you get the parts that match your existing setup. You may also completely change over to new parts here if wished.

Early Part #s	Later Part #s	Description
24-5000BTL 24-6000BTL 24-7000BTL 24-8000BTL	24N-5000BTL 24N-6000BTL 24N-7000BTL 24N-8000BTL	Bail Wires
35-3000PUR 35A-3000SG (O.D. 5/16")	35-5000BTL 35A-5000BTL (O.D. 6/16")	Line Roller Line Roller Ball Bearing
Using a regular ruler, rather than calipers, the bearing measurements are noted to assist with identification.

Notes For Ordering The Parts Below:

• To Order: Click on the check box next to the part number(s), enter the quantity you would like to purchase, then "Add To Cart". This allows you the option of only ordering the parts that you need to replace.
• Upgrade: To completely upgrade to the newer system, order all the parts in the "Later BTL Parts" section below.
• Quantities: If you want to order different quantities of different parts below, just put "1" in the QTY box. When you hit "Add To Cart" button, it goes to the Cart, where you can adjust the quantities and update the order if you wish.